How to factory reset my smart bulb
Most problems with a MagicLight WiFi smart bulb can be fixed by factory resetting your smart bulb. You can do that by following these steps:
1. Power on the bulb and wait for it to turn on.
2. Wait 1-3 seconds and power off the bulb
3. Repeat the above two steps 4 times.
On the fourth attempt, the bulb will enter into a strobe mode. After about 20 seconds, the bulb will turn bright white and the reset is complete.
At this point, you should be able to see the smart bulb's wifi signal (shown up as LEDNetxxx) from your phone's wifi settings.
Now you can go through the setup process to pair the bulb with your home wireless network and you should be all set.